Komatsu — AFTER STORAGE

OPERATION LONG TERM STORAGE BEFORE STORAGE To place the machine in storage for an extended period of time, the following measures must be taken to insure that it can be returned to operation with a minimum of service. After every part is washed and dried, the machine shall be housed in a dry building. Never leave it outdoors. If it is unavoidable to leave it outdoors, park the machine on flat ground and cover it with canvas, etc. Completely fill the fuel tank, lubricate and change oil before storage. Apply a thin coat of grease to the metal surfaces of the hydraulic cylinder piston rods and splined shafts.

Disconnect the negative terminals of the batteries and cover the batteries or remove them from the machine and store them separately. Set each control lever to neutral or hold position, lock them and apply the parking brake. Open the air tank drain valves to completely drain the tanks. After draining, close the drain valves. If the engine will be out of service longer than six (6) months, take special precautions to prevent rust. Contact the nearest Cummins Authorized Repair Location for information concerning engine storage procedures. DURING STORAGE A WARNING!

If it is unavoidably necessary to carry out rust-preventive operation while the machine is indoors, open up doors and windows to improve ventilation and prevent the gas poisoning. l Operate the engine and move the machine for a short distance once a month so the new oil film will be coated over movable parts and component surfaces. l Before operating the work equipment, wipe off the grease on the hydraulic cylinder piston rods. AFTER STORAGE NOTICE:lf the machine is stored without carrying out the monthly rust prevention operation, request your distributor for service. Carry out the following procedure when taking the machine out of long-term storage.

l Wipe off the grease on the hydraulic cylinder piston rods. l Completely fill the fuel tank, lubricate and add oil. 2-70