OPERATION HANDLING OF BATTERY PRECAUTIONS FOR CHARGING BATTERY 1. Before charging, disconnect the cable from the negative (-) terminal of the battery. Otherwise, an unusually high voltage will damage the alternator. 2. While charging the battery, remove all battery caps for satisfactory ventilation, A WARNING! To avoid gas explosions, do not bring fire or sparks near the battery. 3. If the electrolyte temperature exceeds 45°C (113°F) stop charging for a while. 4. Turn off the charger as soon as the battery is charged. Overcharging the battery may cause the following: 1) Overheating the battery 2) Decreasing the quantity of electrolyte. 3) Damaging the electrode plates. 5.
If the electrolyte gets on your skin or clothes, immediately wash with plenty of clean water. 6. Do not mix up battery cables; positive (+) to negative (-) or negative (-) to positive (+), as this will damage the alternator. 7. When inspecting or servicing a battery, be sure to stop the engine and turn the starting switch key to “OFF” position. 8. When performing any service to battery besides checking the electrolyte level or measuring the specific gravity or voltage reading, disconnect the cables from the battery. REMOVAL AND INSTALLATION OF BATTERY l When removing the battery, first disconnect the cable from the ground; normally, from the negative (-) terminal. A WARNING!
If a tool touches a connected positive (+) cable terminal and the chassis, there is danger that it will cause sparks. l When installing the battery, connect the positive (+) cable first and connect the negative (-) or ground cable to the ground terminal last. l Batteries are mounted on both sides of the machine, just in front of the counterweight. The ground cable is connected to the battery, located on the right side. 2-71