OPERATION STARTING ENGINE WITH BOOSTER CABLES When starting the engine with booster cables, do as follows: A WARNING! Be sure to follow all related safety precautions listed in Section 1. BEFORE CONNECTING BOOSTER CABLES 1. The size of the booster cable and clamp should be suitable for the battery size. 2. Check booster cables and clamps for damage or corrosion. 3. Make sure that the cables and clamps are firmly connected. 4. Keep the starting switch in the “OFF” position. 5. The battery of the normal machine must be the same capacity as that of the engine to be started. CONNECTING BOOSTER CABLES Connect the booster cables in the following manner. A WARNING!
When connecting the cables, never contact the positive (+) and negative (-) terminals. A WARNING! Make sure that the booster cable connections are correct. Connect the booster cable to the engine block as far as possible from the battery. @ 0 dl 1. Connect one clamp of booster cable (A) to the posi- tive (+) battery terminal of the engine to be started. 2. Connect the opposite clamp of booster cable (A) to the positive (+) battery terminal of the normal ma- chine. 0 + + 3. Connect one clamp of booster cable (B) to the nega- tive (-) battery terminal of the normal machine. Batteries of problem machine 4. Connect the other clamp of booster cable (B) to the engine block of the problem machine.
Engine block of problem machine L08AH017 * Make sure the cable clamps are firmly connected to the battery terminals. STARTING ENGINE 1. Start the engine of the normal machine and run the engine above low idle speed. 2. Start the engine of the problem machine as outlined under “STARTING ENGINE”. 2-72