OPERATION TROUBLESHOOTING This guide is not intended to cover all conditions, however many of the more common possibilities are listed. l In cases of abnormalities or causes which are not listed below, contact your distributor. ELECTRICAL SYSTEM Lamp does not glow brightly even when engine runs at high speed. Cranking motor turns the engine sluggishly. l Charge the batteries. l Replace the cranking motor. Lamp flickers while engine runs. l Check for loose terminals and open-circuit wiring. l Adjust belt tension. The cranking motor disengages before the engine starts up Charge monitor does not go out even when engine runs at high speed. l Check and repair the wiring. l Charge the batteries.
l Repair or place the alternator. l Inspect and repair wiring. The engine oil pressure monitor does not light up when engine is stationary and when the starting switch is in ON position. Unusual noise is emitted from the alternator. l Replace the monitor. l Repair or replace the alternator. l Replace the monitor sensor. l Inspect and repair the wiring. Cranking motor does not turn when starting switch is turned on. l Inspect and repair the wiring. Charge monitor does not light up when the engine is stationary and when the starting switch is in ON position. l Charge the batteries. l Replace the monitor. The pinion of the cranking motor keeps going in and out. l Inspect and repair the wiring.
l Charge the batteries. ENGINE The engine oil pressure monitor flashes when engine speed is raised after completion of warm-up. The engine does not start when the cranking motor is turned over. l Add the oil to the specified level. l Add fuel. l Replace the oil filters. l Check oil leakage from the pipe or the joint. l Repair where air is leaking into fuel system. l Replace the injection pump or the nozzle. l Replace the monitor. l Check engine valve clearance. Steam is emitted from the top of the radiator at the pressure valve. The engine coolant temperature monitor flashes. l Refer to section for ELECTRICAL SYSTEM. l Check engine compression pressure. Exhaust gas is white or blue.
l Supply the coolant and check for leakage. l Adjust to specified oil quantity. l Adjust fan belt tension. l Clean and flush inside of cooling system. l Replace with specified fuel. l Clean or repair radiator core fins. l Replace engine thermostat. Exhaust gas occasionally turns black. Clean or replace the air cleaner element. Replace the nozzle. Check engine compression pressure. Clean and replace turbocharger. l Tighten the radiator cap firmly or replace the cap if it has a faulty gasket. l Replace the monitor. 2-74