Komatsu — MAINTENANCE GUIDELINES

MAINTENANCE PERIODIC MAINTENANCE Proper lubrication and maintenance assure trouble-free operation and long machine life. Time and money spent for scheduled periodic maintenance will be amply compensated by prolonged machine operation and reduced operating cost. All hourly figures given in the following descriptions are based on service meter readings. In practice, however, it is recommended to rearrange all of them into units of days, weeks and months, to make the maintenance schedule more convenient. Under rough jobsite or operating conditions, it is necessary to somewhat shorten the maintenance intervals stated in this manual.

MAINTENANCE GUIDELINES Perform maintenance work on a hard, flat surface. Use genuine parts specified in the Parts Book as replacement parts. Use genuine oils and grease. Choose oils and grease with proper viscosities specified for the ambient temperature. Use clean oil and grease. Also, keep containers of the oil and grease clean. Keep foreign materials away from oil and grease. Always keep the machine clean. This makes is easier to find parts causing problems. Keep in particular grease fittings, breathers and oil level gauges clean and avoid foreign matters from getting in them. Be careful of hot coolant and oil:

Draining hot oils and coolants and removing their filters immediately after the engine stops are hazardous. Allow the engine to cool. If the oil has to be drained when it is cold, warm up the oil to a suitable temperature (approx. 20”-4O”C [68”-104”F]) before draining it. Check for foreign materials in drained oil: After oil is changed or filters are replaced, check the oil and filters for metallic particles and foreign materials. If large quantities of metallic particles or foreign materials are found, consult your distributor. Fuel strainer: Do not remove the fuel strainer while fueling. Oil changes:

Check or change oils in the places where dust is scarce to keep foreign materials away from oils. Warning tag: Attach the warning tag to the starting switch or other appropriate control lever to avoid someone who is not aware of the circumstances from starting the engine. Obey precautions: During operation, always obey the precautions on the safety product graphics located on the machine. Welding instructions: l Turn off the engine starting switch. l Do not apply more than 200 V continuously. l Connect grounding cable within 1 m (3.3 ft) from the area to be welded. l Avoid seals or bearings from being between the area to be welded and the position of the grounding point. 3-2