Komatsu — COOLANT

MAINTENANCE l Provides engine protection in the following areas: - Solder corrosion/bloom - Copper corrosion/erosion/stress cracking - Oil fouling - Cylinder liner cavitation corrosion - Aluminum cavitation corrosion - Seal and gasket degradation MAINTENANCE OF SUPPLEMENTAL COOLANT ADDITIVES Keeping the engine coolant properly inhibited will keep the engine and radiator free of rust, scale deposits and corrosion. New machines are delivered with antifreeze protection. Service at regular scheduled interval specified in the “SCHEDULED MAINTENANCE GUIDE” with a service DCA4 filter. Each time the coolant is drained and replaced, the coolant must be recharged with SCA.

New coolant can be correctly charged with supplemental coolant additives by using a DCA4 service filter or SCA concentrate listed in the table entitled, “DCA4 Unit Guide”. If coolant is added between drain intervals, additional SCA will be required. COOLANT TESTING FOR CONDITIONER CONCENTRATION When the cooling system is maintained as recommended, the conditioner concentration should be satisfactory. The SCA concentration must not fall below 1 .O unit per 3.8 P (1 US gal) or exceed 2 units per 3.8 P (1 US gal) of coolant. The only accurate method for testing chemical concentrations in coolant with mixed chemical compounds is a laboratory analysis.

For this reason, the coolant inhibitor should be maintained as shown in the “SCHEDULED MAINTENANCE GUIDE”. NOTE: Inadequate concentration of the supplemental coolant additive can result in major corrosive damage to cooling system components. Over concentration can cause formation of “gel” that can cause restriction, plugging of passages and overheating. REPLENISHING COOLANT CONDITIONER Install a “precharge” DCA4 filter when the coolant is changed or a significant (more than 50%) coolant loss occurs. Install a service DCA4 filter as specified in the “SCHEDULED MAINTENANCE GUIDE”. When antifreeze is added, add coolant conditioner equal to 1 .O unit per 3.8 0 (1 US gal) of antifreeze. NOTE:

Mixing of DCA4 and other supplemental coo/ant additives is not recommended because there is currently no test kit available to measure concentration levels with mixed chemical solutions. SCA UNIT MAINTENANCE GUIDE Use supplemental coolant additives (corrosion inhibitors) to protect the engine cooling system from corrosion. Antifreeze alone does not provide enough corrosion protection for a heavy duty diesel engine. Supplemental corrosion protection must be supplied through periodic additions of supplemental coolant additives to the coolant. To protect against corrosion, a new coolant charge must be brought up to 0.26 SCA unit per liter [one unit per U.S. gallon] of coolant (initial charge).

Maintain the correct SCA concentration by changing the service coolant filter at each engine oil and filter change interval. Each time the coolant is drained and replace, the coolant must be recharged with supplemental coolant additives. Use the appropriate DCA4 spin-on filter listed in following table. The coolant mixture must be drained and replaced as defined under “General”. 3-14