MAINTENANCE Wash the element with city water at less than 3 kg/cm2 (43 psi / 296 kPa) of pressure, from the inside along the folds, then from the outside and again from the inside. Dry the element and check it as follows. Using Water With Cleaning Agent NOTICE: The following method requires a spare element. For removing oil and grease as well as carbon etc. on the element, the element may be cleaned in a lukewarm solution of mild detergent, then rinsed in clean water and left to air dry. * Using warm water at about 40°C (104°F) instead of soapy water may also be effective.
* The drying process can be speeded up by appling dry compressed air, at less than 7 kg/cm’ (100 psi / 689 kPa), to the element from the inside to the outside of the element. NOTICE: Never attempt to heat the element. * If small holes or thin areas are found in the element when it is checked with an electric light bulb after cleaning and drying, replace the element. * If the element is reusable, wrap it and store it in a dry place. * Do not use an element which has folds, gasket or seal damaged. * When cleaning the against something.
element, do not hit it or beat it LlZAVOlC TRANSMISSION OIL LEVEL Carry out this procedure if there is any sign of oil on the transmission case, or if there is oil mixed with the engine coolant. A WARNING! When checking the oil level, apply the parking brake, and lock the front and rear frames with the frame locking bar and pin. 1. Stop the engine and remove the cap of oil filler tube (F). 2. Use oil level gauge (G) to check the oil level. 3. The oil level should be between mark ‘I” and “H”, if necessary, add oil at the oil filler tube. 3-26