MAINTENANCE * The type of lubricant used depends on the ambient temperature. Select according to the table entitled “LUBRICANTS, FUEL AND COOLANT”. * There are two sets of level marks on the same side of the oil level gauge: one is for measuring when the engine is stopped “(ENG STOP)“, and the other is for measuring when the engine is idling “(ENG IDLE)“. Engine idling * When measuring the oil level, wait for at least 60 minutes after stopping the engine, and measure with the “ENG STOP” marks. * It is possible to measure the oil level when the engine is at low idle, but in such cases, do as follows.
Start the engine and run it until the oil level is stable, then wait for 5 minutes and measure with the “ENG IDLE’ marks. RADIATOR CORE Carry out this procedure if there is any mud or dirt stuck to the radiator and/or oil cooler. 1. Loosen the four mounting bolts (1) and remove radiator grille (2). 2. Clean the radiator core and oil cooler that are clogged with mud, dirt, etc., with compressed air. Steam or water may be used instead of compressed air. * When cleaning the radiator core and oil cooler, choose a 2 mm (0.07 in) diameter nozzle (3) and use high pressure water at a pressure less than 40 kg/cm2 (569 psi I3923 kPa).
* If it is impossible to remove all mud and dirt when cleaning from the radiator grille side of oil cooler (4), remove engine fan guard (6) and clean from the front side of radiator (5). * Hydraulic oil hoses should be checked at the same time. If a hose is found to have cracks or to be hardened by aging, such a hose should be replaced by new one. Furthermore, check for loosened hose clamps. w LO6ZZOO7 3-27