Komatsu — BUCKET BOLT-ON CUTTING EDGE - IF EQUIPPED

MAINTENANCE 2. Insert the new tooth (1) on to the adaptor (3), and insert pin (2) partway as shown in the diagram. Then drive it home by means of a hammer. * After operating the machine for a few hours, check that the pin does come out. 3 17DHOOOZ BUCKET BOLT-ON CUTTING EDGE - IF EQUIPPED If the bucket bolt-on cutting edge is worn, reverse or replace the cutting edge as follows. * After the cutting edge has been reversed once and is worn out, replace it with a new part. 1. Raise the bucket to a convenient height, and put blocks under the bucket to support it. * Position the bucket so that the bottom is horizontal. 2.

Remove mounting nuts (4), flat washers (5), bolts (3), end cutting edges (2) and center cutting edge (1). * Before installing the cutting edge to the bucket, clean its mounting surface. 3. Install the cutting edges to the bucket. Tighten the mounting bolts and nuts. * Tightening torque: 230 - 280 kgm (1664 - 2025 Ibf ft I2256 - 2745 Nam) * After operating the machine for a few hours, retight- en the mounting bolts again. L17DR003 3-35