MAINTENANCE BUCKET TEETH - IF EQUIPPED BUCKET EQUIPPED WITH BOLT-ON TEETH. When the bucket teeth are worn, replace them as follows. 1. Raise the bucket to a convenient height, and put blocks under the bucket to prevent it from coming down. * Position the bucket so that the bottom is horizontal. 2. Remove mounting bolts and nuts (I), then remove bucket tooth (2). CI 2 L17DHOOE 3. Install the new teeth on the bucket. When installing the teeth, insert a shim so that there is no clearance between the teeth and the top surface of the bucket. * Thickness of shims is 0.5 mm (0.01 in) and 1.6 mm (0.06 in). So the clearance should be less than 0.5 mm (0.01 in). 4.
To prevent any clearance between the tooth and the edge of the bucket, tighten the mounting nut partially, then hit the tip of the tooth with a hammer. * Tightening torque of mounting bolt: 225 + 25 kgm (1627 f 180 Ibf ft / 2206 f 244 N*m) * After operating the machine for a few hours, retighten the mounting bolts again. BUCKET EQUIPPED WITH REPLACEABLE TOOTH TIP Replace the teeth before they wear down as far as the adaptor. 1. Extract pin (2) fitted to the bucket and then remove tooth (1). When extracting pin (2) strike the part (either the left or right part) with a sharp object. This will enable the pin to be extracted from the opposite side. 1 * 3-34