Komatsu — MONITOR PANEL

MAINTENANCE DRIVE BELT TENSION CHART 4 rib 3822524 ST-l 138 620 140 270 - 490 60-110 6 rib 3822525 ST-l 293 710 160 290 - 580 65-130 8 rib 3822525 ST-l 293 890 200 360 - 710 80-160 NOTE: A belt is considered used if has been in service for ten (10) minutes or longer. NOTE: If the used belt tension is less than the minimum value, adjust and tighten the belt to the maximum value. MONITOR PANEL * Always make the checks listed under the section entitled “CHECKS BEFORE STARTING ENGINE”. 1. Turn the starting switch to ON. 2.

Check that all monitor lamps, gauges and the warn- ing lamp light up for about 3 seconds and the alarm buzzer sounds for about 1 second as described under “SYSTEM CHECK’ in Section 2. * If any monitor lamp does not light up, ask your distributor to inspect that monitor lamp. 3-44