Komatsu — BELT TENSION CHECK

MAINTENANCE ENGINE FAN A WARNING! Personal injury can result from a fan blade failure. Never pull or pry on the fan. This can damage the fan blade(s) and cause fan failure. * Rotate the crankshaft by using the crankshaft barring techniques recommended by Cummins Engine Company, inc. Check for cracks, loose rivets, and bent or loose blades. Check the fan to make sure it is securely mounted. Tighten the capscrews if necessary. Replace any fan that is damaged. RA RIM: DRIVE BELTS BELT INSPECTION Visually inspect the drive belts. Replace belts that are cracked or frayed. Adjust belts that have a glazed or shiny surface which indicates belt slippage.

Correctly installed and tensioned belts will show even pulley and belt wear. Belt damage can be caused by: l Incorrect size or length 0 Pulley misalignment 0 Incorrect installation 0 Severe operating environment 0 Incorrect tension --Y 02AA0003 l Oil or grease on the belts BELT TENSION CHECK Measure belt tension at the center point of the longest pulley span using a belt tension gauge. Refer to the following “DRIVE BELT TENSION CHART”, for the correct belt tension gauge and belt tension value for the belt width used. An alternate method, known as the deflection method, can be used to check belt tension by applying 110 N (25 Ibf) of force between the pulleys on the v-belts.

If the deflection is more than one (1) belt thickness per foot of pulley center distance, the belt tension must be adjusted. All new belts will lose tension during use. They must be adjusted to the tension value listed in the following chart. * A belt is considered used if has been in operation for ten (10) minutes or longer. 3-43