MAINTENANCE ENGINE AIR INTAKE SYSTEM Inspect the intake piping for cracked hoses, loose clamps, or punctures which can damage the engine. Tighten or replace parts as necessary to make sure the air intake system does not leak. Check for corrosion of the intake system piping under the clamps and hoses. Corrosion can allow corrosive prod- ucts and dirt to enter the intake system. Disassemble and clean as required. EVERY 100 HOURS SERVICE * Maintenance for every 50 hours should be carried out at the same time. HYDRAULIC TANK OIL LEVEL 1. Lower the bucket horizontally to the ground and stop the engine. Wait for 5 minutes, then check sight gauge (G). Oil should be visible in sight gauge (G). 2.
Add engine oil at oil filler cap (F), if necessary. A WARNING! When removing the oil filler cap, turn it slowly to relieve inner pressure. * The type of lubricant used depends on the ambient temperature. Select according to the table under “LUBRICANTS, FUEL AND COOLANT”. 3-46