MAINTENANCE LUBRICATION Apply grease to the grease fittings shown by the arrows. 1. Rear axle pivot pins (3 points) CAB AIR FILTER - IF EQUIPPED Clean the cab air filters as follows: * Be sure the cab blower fan is stopped before clean- ing the filters. 1. Open the access doors located at the rear of the cab to gain access to the fresh air filter. 2. Remove holder mounting knobs (I), holder (2) and spacers (3) holding filter (4). Pull out the filter ele- ment and clean it. j, Direct dry compressed air (less than 7 kg/cm2 [IO0 psi / 689 kPa]) to the element from the inside along its folds, then direct it from the outside along its folds and again from the inside.
Check the element for damage and/or deterioration. A WARNING! When using compressed air, wear safety glasses and other things required to maintain safety. 3. After cleaning the filter element, reinstall it with the arrow pointing inward. 4. Install filter holder (2) spacers (3) and mounting knobs (1). 5. Close the access doors located at the rear of the cab. 6. Move the operator’s seat forward, then tilt the seat backrest forward and down. 7. Loosen the two access panel thumb screws (5) and retainers (6) and remove access panel (7) to gain access to recirculating air filter (8). Remove air filter and clean it. 8. After cleaning the recirculating air filter, reinstall air filter (8). 9.
Install access panel (7) retainers (6) and thumb screws (5). Tighten the access panel thumb screws. 3-47