MAINTENANCE 7. Fill a new filter with clean engine oil. Then, apply a thin coat of clean engine oil to the seal of the filter. * If the filter is not filled with engine oil, there will be a lack of lubrication during the delay until the filter is pumped full of oil. This lack of lubrication is harmful to the engine. 6. Install the filter on the filter header until the filter seal contacts the seal surface of the filter header and then, turn the filter an additional l/2 to 314 turn by hand. * Do not over tighten the filter or damage may result to the filter seal or threads. * Use a genuine filter. 9. Clean and check the oil drain plug threads and the seal surface.
Reinstall and tighten the oil drain plug. Ll2AM002 IO. Clean and check the oil drain plug threads and the seal surface. Reinstall and tighten the oil drain plug. 11. Remove oil filler cap (F). Fill the engine with the specified type and quantity of engine oil at the oil filler. * Refill capacity: 36 0 (9.5 gal) * The type of lubricant used depends on the ambient temperature. Select according to the table entitled “LUBRICANTS, FUEL AND COOLANT”. 12. After refilling the engine with oil and before starting the engine, perform the procedure outlined under ” SPECIAL STARTING” in Section 2. This procedure insures that the engine receives proper lubricating oil flow.
Lack of lubrication will damage the engine. 13. Start the engine and idle it for a few minutes. Inspect for oil leaks at the filters and drain plug. Then, stop the engine, wait for 5 minutes to allow the oil to drain and check the oil level. As necessary, add oil to bring the oil level up to the specified mark on the oil level gauge. 14. Close the engine side access door. Diluted oil can cause severe damage to the engine. Check the condition of the used oil. * l Thin black oil indicates fuel dilution. l Milky discoloration indicates coolant dilution. 3-50