MAINTENANCE FUEL FILTERS GENERAL The fuel filters are spin-on type filters. These filters cannot be cleaned and should not be disturbed except when it becomes necessary to replace them. Change the fuel filters as listed on the SCHEDULED MAINTENANCE GUIDE or sooner if a power loss is evident. If a power loss persists, consult your distributor. NOTE: Fuel with more than the average impurities may require changing filters at shorter intervals. The fuel filters are located on the right side of the engine. Be careful not to allow dirt, water or other foreign material to get in the new filter. Keep new filters in the original package until ready for installation. REPLACEMENT 1.
Open the engine side access cover on the right side of the machine. 2. Clean the area around the fuel filters. 3. Using a filter wrench, remove the fuel filters by turning them counterclockwise. Discard the filters in a suitable manner if they are not needed for any reason. 4. Clean the filter gasket surfaces of the filter header for each filter. Replace the filter O-rings. 3-51