MAINTENANCE 5. Fill the new filters with clean diesel fuel. Then, apply a thin coat of clean engine oil to the seal of the filter. 6. Install the filters on the filter header until the filter seal contacts the seal surface of the filter header and then, turn the filter an additional l/2 to 3/4 turn by hand. * Do not over tighten the filter or damage may result to the filter seal or threads. * Use a genuine filter. 7. After replacing the filters, start the engine and idle it for a few minutes. Check the filters for possible fuel leakage. Ll2AM002 6. Close the engine side access cover. COOLANT FILTER GENERAL The coolant filter is a spin-on type filter.
This filter cannot be cleaned and should not be disturbed except when it becomes necessary to replace it. Replace the coolant filter at every engine oil change. * The correct coolant filter to be used is determined by the total cooling system capacity and operational factors. For further information, refer to “SCA UNIT MAINTENANCE GUIDE”. The coolant filter is located on the left side of the engine. Be careful not to allow dirt, water or other foreign material to get in the new filter. Keep new filters in the original package until ready for installation. 3-52