MAINTENANCE WHEEL HUB NUTS If wheel hub nuts (1) are loose, tire wear will be in- creased and accidents may be caused. If any hub nuts are loose, tighten them to the specified tightening torque. * Tightening torque: 48 f 5 kgm (347 + 36 Ibf ft / 470 f 49 N*m) * If any wheel mounting studs are broken, replace all studs for that wheel. * Always rotate in the direction of tightening when checking for loose nuts. AIR CONDITIONER COMPRESSOR DRIVE BELT - IF EQUIPPED 1. Open the engine side access door on the right side of the machine. 2. Visually inspect the drive belt. Replace belts that are cracked or frayed. Adjust belts that have a glazed or shiny surface, indicating belt slippage.
Correctly installed and tensioned belts show even pulley and belt wear. 3. Check each belt pulley for damage and pulley groove wear. Particularly, check whether the drive belt is contacting the bottom of the pulley groove through wear. Also, check for pulley alignment. 4. Check belt tension at the midway point of the longest pulley span using the deflection method. * Proper belt deflection is 1 O-15 mm (13/32-19/32 in) when applying approximately 6 kg (13 Ibf / 58 N) of force on the belt between the compressor drive pulley and the magnetic clutch. If the deflection is more than the specified range, the belt tension must be adjusted. 5. If necessary, adjust drive belt tension as follows:
1) Loosen the arm adjusting bolts and the mounting bracket pivot bolt. * When adjusting drive belt tension, do not attempt to move the compressor directly with a bar or similar tool, but use a wood block to prevent damage. 2) Move the compressor to adjust belt tension. 3) When proper belt tension is obtained, tighten the arm adjusting bolts and the mounting bracket pivot bolt securely to hold the compressor in place. 6. Close the engine side access door on the right side of the machine. * If proper belt tension can not be obtained, the drive belt may be stretched, leaving no allowance for adjustment, and should be replaced.
* When the belt is replaced, readjust its tension after running for one (1) hour. 3-59