Komatsu — TRANSMISSION OIL FILTER - S/N A61017 AND BELOW

MAINTENANCE EVERY 500 HOURS SERVICE * Maintenance for every 50,100 and 250 hours should be carried out at the same time. TRANSMISSION OIL FILTER - S/N A61017 AND BELOW 1. Remove drain plugs (1) at the bottom of filter cases (2), and drain the oil. After draining the oil, tighten the plugs. 2. Hold filter cases (2) and loosen center bolts (3) then remove the filter cases. 3. Remove the filter element and clean the inside of the filter case. Assemble a new element, then install the filter case. * Use a genuine oil filter element. * Replace the filter gasket and O-rings with new parts. Coat the gasket and O-rings with clean engine oil before installing.

* Before tightening center bolt (3) install bolt washer (4) so that its chamfered surface faces the hexago- nal head of the center bolt. * Be careful not to apply excessive torque to center bolts (3). * Tightening torque: 18.5 F 1.5 kgm (134 f 11 Ibf ft / 182 f 15 N*m) LO7BVOOGA 4. Run the engine for a short time at idle speed and check for oil leaks. Stop the engine. Check that the transmission oil is at the specified level. For details, see “TRANSMISSION OIL LEVEL”. 3-60