MAINTENANCE 13. Replace the coolant filter as described under “COOLANT FILTER”. Open the coolant filter shut-off valve (I), located on the left side of the engine. 14. Fill the cooling system with the correct mixture of water, antifreeze and the correct amount of SCA units. 15. Run the engine for 5 minutes at low idle to eliminate air trapped in the cooling system, and run the engine for 5 minutes at high idle. Leave radiator cap (2) off during this operation. 16. Stop the engine and 3 minutes later supply the system with the correct mixture of water, antifreeze and the correct amount of SCA units up to the bottom of the radiator filler opening. 17.
Repeat Steps 15 and 16 to ensure that the coolant mixture is up to the bottom of the radiator filler opening. Install and tighten the radiator cap. 18. Close the engine side access door. EVERY 6000 HOURS SERVICE * Maintenance for every 50,100,250,500,1000,1500 and 2000 hours should be carried out at the same time. FUEL PUMP Clean and calibrate the fuel pump. For the detailed procedure, refer to the Engine Operation and Maintenance Manual. FUEL INJECTORS Clean and calibrate the fuel injectors. For the detailed procedure, refer to the Engine Operation and Maintenance Manual. ENGINE FAN HUB Check the engine fan hub.
For the detailed procedure, refer to the Engine Operation and Maintenance Manual. ENGINE IDLER PULLEY Check the engine idler pulley. For the detailed procedure, refer to the Engine Operation and Maintenance Manual. TURBOCHARGER Check the engine turbocharger. For the detailed procedure, refer to the Engine Operation and Maintenance Manual. AIR COMPRESSOR Inspect the air compressor. For the detailed procedure, refer to the Engine Operation and Maintenance Manual. ENGINE VIBRATION DAMPER Inspect the engine vibration damper. For the detailed procedure, refer to the Engine Operation and Maintenance Manual. 3-76