MAINTENANCE A WARNING! Do not remove radiator cap (2) when the engine coolant is hot. Hot coolant may spout out and cause serious personal inj&y.-When removing the radiate; cap, lift the cap lever to relieve the system inner pressure. 3. Remove radiator cap (2) by lifting the cap lever to relieve the system inner pressure and slowly turn it until it comes off. 4. Open radiator drain valve (3). Open engine drain valve (4) on the left side of the crankcase. Allow all coolant to drain. 5. After the coolant has drained, close the radiator drain valve (3) and close engine drain valve (4). Fill the cooling system with clean soft water (ex: city water) up to the radiator filler opening. 6.
When the water reaches the radiator filler opening, start and run the engine at low idle, open radiator drain valve (3) and engine drain valve (4) so the water flows through the cooling system for IO min- utes. When doing this, adjust the water inlet and outlet flows so that the radiator is always full. * 7. After flushing the system with water, stop the engine. Allow the water to drain. 8. After the water has drained, close radiator drain valve (3) and close engine drain valve (4). 9. After draining water, use a flushing agent to clean the cooling system. * Do NOT use caustic cleaners in the cooling system. Aluminum components will be damaged.
* Follow the instructions on the label of the flushing agent used to clean the system. IO. After cleaning the cooling system, again flush the system with soft water until clean water flows out of the drain openings by repeating Steps 4 thru 6. 11. When the water becomes completely clean, stop the engine. Allow the water to drain. L12ZZO35 12. After the water has drained, close radiator drain valve (3) and close engine drain valve (4). 3-75