OPERATION When the bucket control lever is pulled further from 1 position, the lever is stopped in this position until bucket reaches the preset position of positioner, and the lever is returned to the hold position. Dump Tilt 8A. FRONT ATTACHMENT CONTROL LEVER - IF EQUIPPED This lever controls the operation of the optional front mounted work equipment. 9. WORK EQUIPMENT CONTROL LEVER LOCK This is used to lock the lift arm and bucket control levers. A WARNING! When parking or leaving the machine, or when performing maintenance, always lower the bucket to the ground, put the work equipment control levers in the hold position and place the lock lever in the “lock” position.
CAB DOOR HOLD OPEN LOCK - IF EQUIPPED This lock can be used to hold the cab door open. Open the door so that tip (2) of the lever is aligned with groove (1) for the lock, then pull down knob (3) as shown in the diagram. When releasing the lock and closing the door, push up knob (3) and insert pin (4) securely in the groove. * When using the hold open lock, be sure to apply the lock securely. L13CMOl:! 2-27