Komatsu — SEAT BELT

OPERATION SEAT BELT A WARNING! When operating a machine equipped with a ROPS, be sure to use the seat belt. WARNING! Before fastening the seat belt, inspect the mounting brackets and belt for abnormal conditions. A Fasten the belt and remove it in the following manner. 1. Adjust the seat so that the brake pedal can be de- pressed all the way with the operator’s back against the backrest. 2. After positioning the seat, install the tether belt (1). With the seat unoccupied, tense the belt slightly across the seat and install. A WARNING! Check that there are no kinks in the belt. 3. Sit in the seat. Hold buckle (2) and insert tang (3) into the buckle.

Check that the belt has locked by pulling it. 4. When removing the belt, raise the tip of the buckle lever to release it. * When leaving the operator’s seat, release the seat belt and hang it over the arm rest. * Fasten the belt across your body without kinking it. Adjust the lengths of the belt on both the buckle and tang ends so that the buckle is located at the mid-point of your body front. . . . _.. I 1 Adjust the belt length In the tollowlng manner. I I 1. To shorten the belt, pull the free end of the belt at either the buckle or tang end or at both ends. 2. To lengthen the belt, pull the belt while holding it at a right angle to the buckle or tang.

Inspect the seat belt mounting hardware for tight- ness. Retighten any loose bolts to a torque of 2 - 3 kgm (14 - 22 Ibf ft/ 19 - 30 N*m). * * If the seat belt is worn or frayed or if the belt buckle I and/or tang or any of the mounting brackets are damaged or deformed, replace the seat belt immediately. 2-33