OPERATION CAB HEATER AND DEFROSTER - IF EQUIPPED CONTROL PANEL . It is possible to use the cab heater to good effect in dusty jobsites. The outside air is passed through the filter and is sent to the operator’s cab to increase the pressure inside the cab. In this way, dust is prevented from entering, so comfortable operating conditions are always maintained for the operator. 1. FAN SPEED SWITCH This switch controls the air flow when the cab heater is used for heating. * It has three air flow control levels: LO (Low), ME (Medium) and HI (High) * If the outside air is extremely dusty, set the fan speed switch to the HI position. This will pressurize the cab and prevent the dust from entering.
2. TEMPERATURE CONTROL KNOB This knob is used to control the temperature for cooling or heating. * The farther the knob is moved counter-clockwise, the lower the temperature of the air blown out from the vents. * The farther the knob is moved clockwise, the higher the temperature of the air blown out from the vents. 3. AIR INTAKE SELECTOR KNOB This knob switches the air intake port when heating. * FRESH: Operate the knob clockwise. Fresh air is taken in from outside in addition to the air inside the compartment. This is used for ordinary heating and when pressurizing the inside of the cab. I lRF7fMIi * RECIRC: Operate the knob counter-clockwise. Only air inside the compartment is used.
This is mainly used for quick heating. 2-34