OPERATION STARTING ENGINE NORMAL STARTING 1. Depress accelerator pedal (1) lightly. 2. Turn the key of starting switch (2) to the START position to start the engine. 3. When the engine starts, release the key of starting switch (2) and the key will automatically return to the ON position. _ * Do not leave the key in seconds. START for more than 20 OFF * If engine does not start, repeat the starting proce- dure after about 2 minutes. * To start the engine in cold weather, refer to “COLD WEATHER STARTING”. Ll 1 AJo SPECIAL STARTING OFF When starting the engine after running out of fuel, first fill the fuel tank and then, fill the fuel filter with fuel before starting.
Refer to “FUEL FILTERS’ in Section 3. When starting the engine after each engine oil change or after the engine has been shut off for more than three (3) days, perform the following steps to insure the engine receives proper lubricating oil flow through the lubricating system. l Disconnect the electrical wire from the fuel pump solenoid valve. L11AJOll l Using the starting switch, crank the engine by the cranking motor until the oil pressure monitor lamp goes out. l Reconnect the electrical wire to the fuel pump solenoid valve. l Start the engine as described under “NORMAL STARTING”. 2-44