Komatsu — COLD WEATHER STARTING

OPERATION COLD WEATHER STARTING When starting the engine in low temperatures, do as follows. 1. Turn the key of starting switch (1) to the START position. 2. Move ether start switch (2) to the ON position, then release it immediately. Do NOT hold it at the ON position for more than 5 seconds. This will cause failure of the ether start valve solenoid. > LllAM03: * If the engine does not start, repeat this 2-3 times. When the engine starts, release the key of starting switch (1) and the key will automatically return to the ON position. A 3. OFF WARNING! Never operate ether start switch (2) except when starting the engine. The ether cylinder can be used for about 230 times.

(Amount of ether injected: 3 cc, total capacity for one cylinder: 710 cc) * START Ll 1 AJoo9 * Do not leave the key in START for more than 20 seconds. * If engine does not start, repeat the starting procedure after about 2 minutes. * The standard specification machine is designed to work in an ambient temperature down to -20°C (-4°F). * When operating the machine at temperatures below -20°C (4”F), special equipment is needed. Contact your distributor for details.

ON \ * For machines with an air dryer installed as an option, when in cold temperatures below -10°C (+14”F) and when operating the machine after it has been stopped for several hours, run the engine for at least 10 minutes after starting before moving the machine. OFF ,,% 2-45