OPERATION OPERATIONS AFTER STARTING ENGINE After starting the engine, do not immediately start opera- tions. First, carry out the following operations and checks. 1. Depress accelerator pedal (1) lightly and run the engine with no load at midrange speed for about 3 to 5 minutes. 2. After warm-up run is completed, check monitor lamps for proper operation. * Continue to run the engine at light load until the green ranges of the engine coolant temperature gauge and torque converter oil temperature gauge light up. 3. Check if the exhaust color is normal or whether there is any abnormal noise or vibration. 4.
If the ambient temperature is less than 0°C (32°F) perform the “COLD WEATHER WARM-UP PROCEDURE”, which follows. * Avoid sudden acceleration of the engine until the completion of warm-up. * Do not run the engine at low idle continuously for more than 10 minutes. COLD WEATHER WARM-UP PROCEDURE When starting the engine in cold weather, do not start operations immediately. First, carry out the following. 1. Warm up the engine. Following is the guideline for warming-up time with the engine idling. Ambient temperature -20°C (-4°F) -10°C (14°F) 0°C (32°F) and Above Warm-up time 15 minutes 10 minutes 5 minutes * Avoid sudden acceleration of the engine before the warming-up operation is completed.
* Do not idle the engine continuously for more than 20 minutes. 2. Warm up the work equipment circuits. After completing the warming-up operation for the engine, warm up the work equipment circuit. 1) Move the lift arm control lever slowly to the RAISE position and raise the bucket slightly. 2) Move the lift arm control lever slowly to the LOWER position and lower the bucket slightly. 3) Repeat the above operation several times and gradually increase the amount you move the lift cylinders. 4) Repeat Steps 1) - 3) for the bucket control lever to warm up the work equipment circuit. * Run the engine with the throttle at the l/3 position or below. 2-46