OPERATION 5) Raise the bucket 10 - 30 cm (3.7 - 11.8 in) from the ground, operate the bucket control lever to the tilt position, relieve the circuit for approximately 5 seconds, then return the lever to the neutral position and hold it for approximately 2 seconds. Repeat this operation to warm up the work equipment circuit. * Raise the engine speed gradually from the idling speed. A WARNING! If the machine is operated suddenly before the warming-up operation is carried out, the work equipment may be damaged. The warming-up operation is also mandatory for safety reasons. 3. Warm up the steering circuit as follows. A WARNING!
If this operation is carried out when the oil temperature is still low, even when the steering wheel is turned and stopped, there may be a time lag before the chassis turns or stops. In such cases, carry out the warming-up operation in a large open area. In addition, use the safety bar to ensure safety. In this case, do not relieve the circuit for more than 5 seconds. 4. Turn the steering wheel slowly to the left and right to warm up the oil inside the steering valve. Repeat this operation about 10 times. * Turn the steering wheel a short distance, then stop it, and check that the chassis stops according to the amount the steering wheel is turned.
* The recommended oil for the work equipment hydraulic system depends on the ambient temperature. Select oil according to the table under “LUBRICANTS, FUEL AND COOLANT” in Section 3. MOVING MACHINE OFF 1. Check that a warning item is not displayed on the monitor panel. 2. Free the work equipment control lever lock for the equipment control levers. Place the work equipment in the traveling position. 3. Depress right brake pedal (I), and turn parking brake switch (2) to OFF to release the parking brake. 2-47