OPERATION ADJUSTMENT OF WORK EQUIPMENT The boom kickout makes it possible to set the bucket so that it automatically stops at the desired lifting height (lift arm higher than horizontal) and the bucket positioner makes it possible to set the bucket so that it automatically stops at the desired digging angle. The setting can be adjusted to match the working conditions. ADJUSTING BOOM KICKOUT 1. Raise the bucket to the desired height, set the lift arm control lever at HOLD and lock the lever in position. Then stop the engine and adjust as follows. 2.
Loosen two bolts (I), and adjust plate (2) so that the bottom edge is in line with the center of the sensing surface of the proximity switch under switch cover (3). Then tighten the bolts to hold the plate in posi- tion. 3. Loosen the two nuts (4) and adjust to make a clear- ance of 3 - 5 mm (0.12 - 0.20 in) between plate (2) and the sensing surface of the proximity switch under switch cover (3). Then tighten the nuts to hold the switch in position. * Tightening torque: 1.75 f 0.25 kgm (12.7 + 1.8 Ibf ft / 17.2 + 2.4 Nmm) 4. After adjusting, start the engine and operate the lift arm control lever.
Check that the lever is automati- cally returned to HOLD when the bucket reaches the desired height. 2-60