OM3038 8/03 Operating Instructions - Section 30 Page 30-5 3. If truck is equipped with auxiliary cold weather heater system(s), do not attempt to start engine while heat- ers are in operation . Damage to coolant heaters will result! 4. The keyswitch is a three position (OFF, RUN, START) switch. When the switch is rotated one position clock- wise, it is in the RUN position and all electrical circuits (except START) are activated. a. Turn keyswitch to RUN (not START) position. b. With selector switch in NEUTRAL, rotate key- switch fully clockwise to START position, and hold this position until engine starts (see NOTE below).
The START position is spring-loaded and will return to RUN when the key is released. c. After the engine has started, place rest switch in the OFF position (de-activate the "rest" mode of operation). Refer to Operator Cab and Controls for more information on the rest switch. NOTE: This truck is equipped with an engine prelube system. With this feature, a noticeable time delay may occur (while engine lube oil passages are being filled and pressurized) before engine cranking will begin. Cold Weather Starting Do not crank an electric starter for more than 30 seconds. Allow two minutes for cooling before attempting to start the engine again.
Severe damage to the starter motors can result from overheating. AFTER ENGINE HAS STARTED 1. Become thoroughly familiar with steering and emergency controls. After engine has started and low pressure and warning systems are normal, test the truck steering in extreme right and left directions. If the steering system is not operating properly, shut the engine down, immediately. Determine the steering system problem and have repaired before resuming operation. 2. Operate each of the truck's brake circuits at least twice prior to operating and moving the truck. These circuits include individual activation from the operator's cab of the service brake, parking brake, and brake lock.
With the engine running and with the hydraulic circuit fully charged, activate each circuit, individually. If any applica- tion or release of any brake circuit appears sluggish or improper, or if warning alarms are activated on appli- cation or release, shut the engine down and notify maintenance personnel. Do not operate the truck until the brake circuit in question is fully operational. 3. Check gauges, warning lights and instruments before moving the truck to ensure proper system operation and proper instrument functioning. Give special attention to braking and steering circuit hydraulic warning lights. If warning lights come on, shut down the engine immediately and determine the cause.
4. Insure headlights, worklights and taillights are in proper working order. Good visibility may prevent an acci- dent. Check operation of windshield wiper. 5. When truck body is in dump position, do not allow anyone beneath it unless body-up retaining pin or cable is in place. 6. Do not use the fire extinguisher for any purpose other than putting out a fire! If extinguisher is discharged, report the occurrence so the used unit can be refilled or replaced. 7. Do not allow unauthorized personnel to ride in the truck. Do not allow anyone to ride on the ladder of the truck. 8. Do not leave the truck unattended while the engine is running.
Shut down the engine and apply the park brake before getting out of the cab.