Operating Instructions - Section 30 8/03 OM3038 Page 30-4 26. Before climbing ladder to first level, be sure ground level engine shutdown switch is ON. Inspect fire control actuator to be sure safety pin is in place and plastic tie that prevents accidental actuation is in place and in good condition. Be sure battery disconnect switches are ON. Always use grab rails and ladder when mount- ing or dismounting the truck. Clean ladder and hand rails of any foreign material, such as ice, snow, oil or mud. 27. Use stairs and handrails while climbing from first level to cab deck. Always mount and dismount ladders facing the truck. Never attempt to mount or dismount while the truck is in motion. 28.
When checking coolant level in the radiator, use coolant level sight gauge. If it is necessary to remove the radiator cap, shut down engine (if running), and relieve coolant pressure by slowly removing the radiator cap. If the engine has been running, allow the coolant to cool before removing the fill cap or draining the radia- tor. Serious burns may result if skin comes in contact with hot coolant. 29. Inspect covers over retarding grids to be sure latches are in place and secure. Inspect main air inlet to be sure it is clear. Ensure all cabinet door latches are secure. 30. Move around the cab to the back. Open the doors to the brake cabinet; inspect for leaks. 31.
Clean cab windows and mirrors; clean out cab floor as necessary. Ensure steering wheel, controls and pedals are free of any grease or mud. 32. Stow personal gear in cab so that it does not interfere with any operation of the truck. Dirt or trash buildup, specifically in the operator's cab, should be cleared. Do not carry tools or supplies in the cab of truck or on the deck. Exhaust fumes are dangerous! before starting. g wheel for use. he description of all operator controls listed in Operator s and functions before operating the truck. ENGI PRAC RT THE ENGINE BY SHORTING ACROSS THE STAR y or death to anyone in machine’s path. THE OPERATOR’S SEAT ONLY.
re clear of truck before starting engine. Always sound al controls. If the truck is in an enclosure, ensure adequ Cab and NE STA ENGI PRAC THE ENGINE BY SHORTING ACROSS THE STAR r death to anyone in machine’s path. HE OPERATOR’S SEAT ONLY. clear of truck before starting engine. Always sound controls. If the truck is in an enclosure, ensure adequ NE gerous! ake switc position ( and Cont rous! e switc osition (