Komatsu — LOADING

OM3038 8/03 Operating Instructions - Section 30 Page 30-7 5. Use extreme caution when approaching a haul road intersection. Maintain a safe distance from oncoming vehicles. 6. Maintain a safe distance when following another vehicle. Never approach another vehicle from the rear, in the same lane, closer than 50 ft. (15 m). When driving on a down grade, this distance should not be less than 100 ft. (30 m). 7. Do not stop or park on a haul road unless unavoidable. If you must stop, move truck to a safe place, apply parking brake, and shut down engine before leaving cab. Block wheels securely and notify maintenance per- sonnel for assistance. 8.

Before starting up or down a grade, maintain a speed that will insure safe driving and provide effective retard- ing under all conditions (Refer to Operator Cab and Controls - Dynamic Retarding. The grade/speed retard chart in the operator's cab should always be referenced to determine maximum safe truck speeds for descending various grades with a loaded truck. 9. When operating truck in darkness, or when visibility is poor, do not move truck unless all headlights, clear- ance lights, and tail lights are on. Do not back truck if back-up horn or lights are inoperative. Always dim head- lights when meeting oncoming vehicles. 10.

If the "emergency steering" light and/or "low brake pressure warning" light (if equipped) illuminate during oper- ation, steer the truck immediately to a safe stopping area, away from other traffic if possible. Refer to item 7 above. 11. Check tires for proper inflation periodically during shift. If truck has been run on a "flat", or under-inflated tire, it must not be parked in a building until the tire cools. STARTING ON A GRADE WITH A LOADED TRUCK Initial propulsion with a loaded truck should begin from a level surface whenever possible. There are circum- stances when starting on a hill or grade cannot be avoided; use the following procedure: 1.

Fully depress the foot-operated retarder/service brake pedal (Do Not use retarder lever) to hold the truck on the grade. With service brakes fully applied, move the selector switch to a drive position (FORWARD/ REVERSE) and increase engine rpm with throttle pedal. 2. As engine rpm approaches maximum, and operator senses propulsion effort working against the brakes, release the brakes and let truck movement start. Be sure to completely release the foot-operated retarder/ser- vice brake pedal. As truck speed increases above 3-5 mph (5-8 kph) the Propulsion System Control (PSC) will drop propulsion, if the retarder is still applied.

Releasing and reapplying dynamic retarding during a hill start operation will result in loss of propulsion. PASSING 1. Do not pass another truck on a hill or blind curve! 2. Before passing, make sure the road ahead is clear. If a disabled truck is blocking your lane, slow down and pass with extreme caution. 3. Use only the areas designated for passing. LOADING 2. Do not drive over unprotected power cables. 1. Pull into the loading area with caution. Remain at a safe distance while truck ahead is being loaded. 3. When approaching or leaving a loading area, watch out for other vehicles and for personnel working in the area. 4.

When pulling in under a loader or shovel, follow "spotter" or "shovel operator" signals. The truck operator may speed up loading operations by observing the location and loading cycle of the truck being loaded ahead, then follow a similar pattern. 5. During loading, the operator must stay in the truck cab with engine running. Place the selector switch in NEU- TRAL and apply the brake lock. 6. When loaded, pull away from shovel as quickly as possible but with extreme caution.