Operating Instructions - Section 30 8/03 OM3038 Page 30-8 DUMPING Raising The Dump Body 1. Pull into dump area with extreme caution. Make sure area is clear of persons and obstructions, including overhead utility lines. Obey signals directed by the spotter, if present. Avoid unstable areas. Stay a safe distance from edge of dump area. Position the truck on a solid, level surface before dumping. As the body raises, the truck center of gravity will move. Truck must be on The dumping of very large rocks (10% of payload, or greater) or sticky material (loads that do not flow freely from the body) may allow the mate- rial to move too fast and cause the body to move rapidly and suddenly.
This sudden movement may jolt the truck violently and cause possible during "hoist up" will hold the body at that position.) 5. Raise engine rpm to accelerate hoist speed. Refer to the CAUTION below. If dumping very large rocks or sticky material as described in WARNING above, slowly accelerate engine rpm to raise body. When the material starts to move, release hoist lever to HOLD position. If material does not continue moving and clear body, repeat this procedure until material has cleared body. 6. Reduce engine rpm as last stage of hoist cylinder begins to extend and let engine go to low idle as last stage reaches half-extension. 7.
Release hoist lever as last stage of hoist cylinder reaches full extension. 8. After material being dumped clears body, lower body to frame. Lowering The Dump Body (When dumping on flat ground): It is very likely when dumping on flat ground that the dumped material will build up enough to prevent the body from lowering. In this case, the truck will have to be driven forward a short distance (just enough to clear the material) before the body can be lowered. 1. Shift selector switch to FORWARD, release brake lock, depress override button and drive just far enough for- ward for body to clear material. Stop, shift selector switch to NEUTRAL, and apply brake lock. 2.
Move hoist lever forward to DOWN position and release. Releasing the lever places hoist control valve in the FLOAT position allowing the body to return to frame. As the body raises, level surface to pre 2. Carefully maneuver truck into dump position. Wh ated brake pedal to stop and hold truck; Do not re ulated and applies rear service brakes only. 3. When truck is stopped and in dump position, ap NEUTRAL position. The dumping of ve material (loads that rial to move too fa This sudden move injury to the operator, and/or damage to the hoist sary to dump this kind of material, refer to the WAR 4. Pull the lever to the rear to actuate hoist circuit.
( m ri T injury to the operator, and/or da sary to dump this kind of materia