Komatsu — Lowering The Dump Body

OM3038 8/03 Operating Instructions - Section 30 Page 30-9 NOTE: If dumped material builds up at the rear of the body and the body cannot be lowered, then perform Steps "a" and "b" below: a. Move hoist lever back to the RAISE position to fully raise the dump body. Then release the hoist lever so it returns to the HOLD position. b. Shift selector switch to FORWARD, release brake lock, depress override button and drive forward to clear the material. Stop, shift selector switch to NEUTRAL, apply brake lock and lower body again. NOTE:

Failure to "hoist" the body after making an unsuccessful attempt at lowering the body may result in the dump body suddenly lowering after the truck has pulled ahead of the material that was previously preventing the body from lowering. CAUTION! The truck is not to be moved with the dump body raised except for emergency purposes only. Failure to lower body before moving truck may cause damage to hoist cylinders, frame and/or body hinge pins. 3. With body returned to frame, move selector switch to FORWARD, release brake lock, and leave dump area carefully. Lowering The Dump Body (When dumping over a berm or into a crusher): 1. Move hoist lever forward to DOWN position and release.

Releasing the lever places hoist control valve in the FLOAT position allowing the body to return to frame. NOTE: If dumped material builds up at the rear of the body and the body cannot be lowered, perform steps "a" & "b" below: a. Move hoist lever back to the HOIST position to fully raise the dump body. Release the hoist lever so it returns to the HOLD position. NOTE: DO NOT drive forward if the tail of body will not clear the crusher wall in the fully raised position. b. Shift selector switch to FORWARD, release brake lock, depress Override button and drive forward to clear the material. Stop, shift selector switch to NEUTRAL, apply brake lock and lower body again. NOTE:

Failure to "hoist" the body after making an unsuccessful attempt at lowering the body may result in the dump body suddenly lowering after the truck has pulled ahead of the material that was previously preventing the body from lowering. CAUTION! The truck is not to be moved with the dump body raised except for emergency purposes only. Failure to lower body before moving truck may cause damage to hoist cylinders, frame and/or body hinge pins. 2. With body returned to frame, move selector switch to FORWARD, release brake lock, and leave dump area carefully.