Operator Cab And Controls - Section 32 OM3202 Page 32-2 STEERING WHEEL AND CONTROLS The steering wheel (1, Figure 32-2) will telescope "in" and "out" and adjust through a tilt angle to provide a comfortable wheel position for most operators. Horn Button The horn (2, Figure 32-2) is actuated by pushing the button in the center of the steering wheel. Operation of the horn should be verified before moving the truck. Observe all local safety rules regarding the use of the horn as a warning signal device before starting engine and moving the vehicle. Telescope Lock Ring The telescope lock ring (3, Figure 32-2) around the horn button locks/unlocks the telescoping function of the steering column.
Rotating the ring 90° - 180° counterclockwise (L.H. rotation), releases the column to move "in" or "out". Rotating the ring clockwise (R.H. rotation), locks the column in the adjusted posi- tion. FIGURE 32-2. STEERING WHEEL AND DYNAMIC RETARDING Tilt Wheel Lever Dynamic retarding is a braking torque (not a brake) produced through electrical generation by the wheel- motors when the truck motion (momentum) is the propelling force. Adjust the tilt of the steering wheel by pulling tilt wheel lever (4, Figure 32-2) toward the steering wheel and moving the wheel to the desired angle. Releasing the lever will lock the wheel in the desired location.
For normal truck operation, dynamic retarding should be used to slow and control truck speed . Turn Signal/Headlight Dimmer Dynamic retarding is available in FORWARD/ REVERSE at all truck speeds above 0 mph/kph; however, as the truck speed slows below 3 mph (4.8 kph), the available retarding force may not be effec- tive. Use the service brakes to bring the truck to a complete stop. Turn signal lever / headlight dimmer (5, Figure 32-2) is used to activate turn signal lights and to select either high or low headlight beams. Move the lever upward to signal a turn to the right.
Dynamic retarding will not hold a stationary truck on an incline; use the parking brake or wheel brake lock for this purpose. An indicator in the top, center of the instrument panel will illuminate to indicate turn direction selected. Refer to Instrument Panel and Indicator Lights in this section. Dynamic retarding is available in NEUTRAL only when truck speed is above 3 mph (4.8 kph). When dynamic retarding is in operation, engine rpm will automatically go to an advance retard speed set- ting. This rpm will vary depending on temperature of Move the lever downward to signal a turn to the left. Moving the lever toward the steering wheel changes headlight beam.
When high beams are selected, the indicator in the top, center of the instrument panel will illu- minate. automatically , if the speed of the truck obtains the maximum speed setting programmed in the control system software. When dynamic retarding is activated, an indicator light in the overhead display will illuminate. The grade/speed retard chart should always be used to determine safe downhill speeds. Refer to Grade/ Speed Retard Chart in this chapter. Whe will a n dyna utomati a g en tor panel will illu-