Komatsu — Starting on a Grade With a Loaded Truck

OM3202 Operator Cab And Controls - Section 32 Page 32-3 Retarder Control Lever Retarder control lever (6, Figure 32-2) mounted on the right side of the steering column can be used to modulate retarding effort. The lever will command the full range of retarding and will remain at a fixed posi- tion when released. Service brakes should be applied only when dynamic retarding requires additional braking force to slow the truck speed quickly, or when bringing the truck to a complete stop . Accelerator (Throttle) Pedal a. When the lever is rotated to full “up” (coun- terclockwise) position, it is in the OFF/no retard position. An adjustable detent holds the lever in the OFF position.

Refer to Sec- tion J in the service manual for adjustment procedures. b. When the lever is rotated to full "down" (clockwise) position, it is in the full ON/retard position. c. For long downhill hauls, the lever may be positioned to provide desired retarding effort, and it will remain where it is positioned. The accelerator (throttle) pedal (4, Figure 32-1) is a foot-operated pedal which allows the operator to con- trol engine rpm, depending on pedal depression. It is used by the operator to request torque from the motors when in forward or reverse. In this mode, the propulsion system controller commands the correct engine speed for the power required.

In NEUTRAL, this pedal controls engine speed directly. NOTE: The retarder control lever must be rotated back to the OFF position before the truck will resume the propel mode of operation. The lever and foot-operated retarder/service brake pedal can be used simultaneously or independently. The Propulsion System Controller (PSC) will deter- mine which device is requesting the most retarding effort and apply that amount. Dynamic Retarder/Service Brake Pedal Starting on a Grade With a Loaded Truck Dynamic retarder/service brake pedal (3, Figure 32- 1) is a single, foot-operated pedal that controls both retarding and service brake functions.

The first por- tion of pedal travel commands retarding effort through a rotary potentiometer. The second portion of pedal travel modulates service brake pressure directly through a hydraulic valve. Thus, the operator must first apply, and maintain, full dynamic retarding in order to apply the service brakes. Releasing the pedal returns brake and retarder to the OFF position. Initial propulsion with a loaded truck should begin from a level surface whenever possible, but when there are circumstances where starting on a hill or grade cannot be avoided, use the following proce- dure: 1.

Fully depress the foot-operated retarder/ser- vice brake pedal (Do Not use retarder lever) to hold the truck on the grade. With service brakes fully applied, move the selector switch to a drive position (FORWARD/REVERSE) and increase engine rpm with throttle pedal. When the pedal is partially depressed, the dynamic retarding is actuated. As the pedal is further depressed, to where dynamic retarding is fully applied; the service brakes (while maintaining full retarding) are actuated through a hydraulic valve which modulates pressure to the service brakes. Completely depressing the pedal causes full application of both dynamic retarding and the service brakes.

An indicator light in the overhead panel (B3, Figure 32-8) will illuminate), and an increase in pedal resistance will be felt when the ser- vice brakes are applied. 2. As engine rpm approaches maximum, and operator senses propulsion effort working against the brakes, release the brakes and let truck movement start. Be sure to completely release the foot-operated retarder/service brake pedal. As truck speed increases above 3-5 mph (5-8 kph) the Propulsion System Control (PSC) will drop propulsion if the retarder is still applied.

Releasing and reapplying dynamic retarding during a hill start operation will result in loss of propulsion and, if truck speed is above 1-2 mph, application of retarding effort. For normal truck operation, dynamic retarding (lever or foot-operated pedal) should be used to slow and control the speed of the truck .