Operator Cab And Controls - Section 32 OM3202 Page 32-10 OPERATOR COMFORT OPERATOR SEAT The operator's seat provides a fully adjustable cush- ioned ride for driver comfort and easy operation. Adjustment The following adjustments are available to the opera- tor while sitting in the seat. Headrest (1, Figure 32-5): Adjust up, down, fore, or aft by moving headrest to desired position. Armrests (3): Rotate adjusting knob until armrest is at desired angle. Backrest: Rotate knob (9) to adjust the backrest angle. Seat Belt Harness: Operator must always have four-point seat belt harness (2) buckled in place and properly adjusted during machine operation. Air Lumbar Support:
Use lumbar hand pump (8) to adjust the air support. A release button on the back of the hand pump releases the air from the lumbar support. Weight Adjustment: Adjust the weight adjustment dial to match the approximate weight of the operator. The dial ranges from 110 - 265 lbs. (50 - 120 kg). Fore/Aft Adjustment: Lift lever (8) and hold. Slide the seat to a comfortable position and release the lever to lock the adjustment. Seat Height: Lift lever (7) and then push the lever down to raise the seat one level. Remove body weight from the seat to allow it to adjust. To lower the seat one level, push lever (7) down, and then pull the lever up. Release lever to lock the adjustment. FIGURE 32-5.
OPERATOR’S SEAT 1. Headrest 2. Seat Belt 3. Armrest 4. Seat Belt Anchor 5. Weight Adjustment Dial 6. Fore/Aft Lever 7. Seat Height/Tilt Adjustment Lever 8. Lumbar Pump 9. Backrest Angle Adjustment Knob Seat Tilt: Pull lever (7) up to tilt the seat rearward. Push the lever down to tilt the seat forward. Release the lever to lock the adjustment.