OM3202 AC Drive System Temperature Gauge the system. Hourmeter tion. Hydraulic Oil Temperature Gauge the oil. ure 32-8) that will illuminate when the temperature exceeds a certain level (when the needle enters the red zone). If this condition occurs, the operator should safely stop the truck, move selector switch to NEUTRAL, apply the park brake, and operate engine at 1200 - 1500 rpm to reduce system temperature. If temperature gauge does not move into the green range after a few minutes, and the red overhead indica- tor light does not go out, shutdown truck and notify maintenance personnel, immediately.
Rest switch (26, Figure 32-7) is a "rocker" type switch with a locking device for the OFF (left side) position. When in this position, a small black tab must be pushed to the left to unlock the switch before it can be depressed to switch to the ON (right side) position. When in the ON position, an internal amber lamp will illuminate. The switch should be activated to de-energize the AC drive system whenever the engine is to be shut- down, or the truck parked for a length of time with the engine running. Rest Switch The selector switch must be in NEUTRAL and the vehicle not moving to enable this function.
This will allow the engine to continue running while the AC drive system is de-energized. Activation of the rest switch alone does NOT completely ensure that the drive system is safe to work on. Refer to Section 2, Safety, for more information on servicing a 930E truck. Check all "link-on", or "link energized", indicator lights to verify the AC drive system is de-engergized before performing any maintenance on the drive system. DO NOT activate the rest switch while the truck is moving! The truck may unintentionally enter the “rest” mode after stopping.
An amber (yellow) indicator light in the overhead panel (B6, Figure 32-8) will illuminate when the "rest" state has been requested and entered. O perator Cab And Controls - Section 32 Page 32-19 stem temperature. mal operation. ellow) temperature en the temperature consider changing gauge (23, Figure 32-7) indicates the drive system temperature. s: green; yellow; and red. Green indicates normal operation. emperature is rising. There is also an amber (yellow) temperature panel (C5, Figure 32-8) that will illuminate when the temperature en this condition occurs, the operator should consider changing duce system temperature.
rature should reach the red band, continued operation could damage components in n engine, and notify maintenance personnel, immediately. registers the total number of hours the engine has been in opera- Gauge uge (25, Figure 32-7) indicates oil temperature in the hydraulic ands: green, and red. Green indicates normal operation. e red zone, minimum engine idle speed will increase to help cool rature in the hydraulic tank. Continued operation could damage system. There is also a red temperature warning light in the overhead panel (D5, Fig- e sy stem temperature. mal operation. ellow) temperature en the temperature consider changing reen; yellow; and red. Green indicates normal operation.
perature is rising. There is also an amber (yellow) temperature nel (C5, Figure 32-8) that will illuminate when the temperature this condition occurs, the operator should consider changing e system temperature. ure should reach the red band, continued operation could damage components in ngine, and notify maintenance personnel, immediately. sters the total number of hours the engine has been in opera- ge (25, Figure 32-7) indicates oil temperature in the hydraulic ds: green, and red. Green indicates normal operation. d zone, minimum engine idle speed will increase to help cool ure in the hydraulic tank. Continued operation could damage tem.
There is also a red temperature warning light in the overhead panel (D5, Fig- normal operation. r (yellow) temperature when the temperature uld consider changing mal operation. ellow) temperature en the temperature consider changing