Operator Cab And Controls - Section 32 Page 32-26 A5. No Power This red “no retard/no propel” indicator light indicates a fault has occurred which has eliminated the retarding and propulsion capability. A warning buzzer will also sound. If this condition occurs, the operator should safely stop the truck, move selector switch to NEUTRAL, apply the parking brake, shutdown the engine, and notify maintenance personnel immediately. B5. Propulsion System Warning When this amber indicator is illuminated, the light indicates a “no propel” or “no retard” event may be about to occur. It is intended to provide advance notice of these events when possible.
It does not require the operator to stop the truck, but may suggest that truck operation be appropriately modified, in case a red alarm does occur. C5. Propulsion System Temperature This amber AC drive system temperature warning light indicates the drive system temperature is above a certain level. When this condition occurs, the operator should consider modifying truck operation in order to reduce system temperature. The operator is not required to stop the truck at this time. D5. High Hydraulic Oil Temperature This red warning light indicates high oil temperature in the hydraulic tank. Several things occur before the red light illuminates:
If the truck is moving, and the oil temperature exceeds 221° F (105° C), the minimum idle speed will be 1200 rpm (normally 1050). If the truck is moving, and the oil temperature goes above 230° F (110° C), the minimum idle speed will be 1700 rpm (normally 1050). 1000 rpm (normally 750). could damage components in the hydraulic system. parking brake, and operate engine at 1200 - 1500 rpm to reduce system temperature. head indictor light does not go out, notify maintenance personnel immediately. E5. Stop Engine This red engine monitor warning light will illuminate if a serious engine malfunction is detected in the electronic engine control system.
Electric propulsion to the wheel motors will still be available. Dynamic retarding will still be available if needed to slow or stop the truck. apply parking brake. SHUT DOWN THE ENGINE IMMEDIATELY. Additional engine damage is likely to occur if operation is continued. An example of a condition that could cause the stop engine light to illuminate: If engine governor senses an overspeed condition, the ECM will close the fuel solenoid and stop the flow of fuel to the engine until engine speed is back within normal operating range. OM3202 d h e t . e e g e . Several things occur C), the minimum idle 110° C), the minimum (100° C) the minimum idle speed will be ne rpm will return to normal speed.
ove 248° F (120° C). Continued operation e selector switch to NEUTRAL, apply the temperature. nge after a few minutes, and the red over- iately. malfunction is detected everal things occur , the minimum idle ° C), the minimum 00° C) the minimum idle speed will be pm will return to normal speed. 248° F (120° C). Continued operation elector switch to NEUTRAL, apply the mperature. after a few minutes, and the red over- ely. function is detected r ed nd