Komatsu — Reserve Oil Tank Filling Procedure (Remote fill)

Lubrication & Service - Section 40 OM4036 Page 40-2 COOLANT LEVEL CHECK RESERVE ENGINE OIL SYSTEM (Optional) Inspect the coolant sight gauge. If coolant cannot be seen in the sight gauge, it is necessary to add cool- ant to the system before truck operation. Refer to the procedure below for the proper filling procedure. The reserve oil tank for the engine is designed to add more oil capacity to the engine to reduce the frequent servicing of the engine oil. The engine oil level must still be checked every shift using the dipstick. If engine oil level is not correct, check for proper opera- tion of reserve oil system. Never add oil to engine unless it has been drained.

RADIATOR FILLING PROCEDURE If the engine oil has been drained from the oil pan, the new oil must be added to the engine oil pan before starting. Do Not use the oil in the reserve tank to fill an empty engine with oil. After an oil change, both engine and reserve tank must be full of oil before starting the engine. Cooling system is pressurized due to thermal expansion of coolant. Do Not remove radiator cap while engine and coolant are hot. Severe burns may result. 1. With engine and coolant at ambient tempera- ture, remove radiator cap. Reserve Oil Tank Filling Procedure (Remote fill) Note:

If coolant is added using the Wiggins quick fill system, the radiator cap MUST be removed prior to adding coolant. 1. Connect the pressure supply hose from the new oil supply to the quick coupler on the truck. Open valve on supply hose to apply pressure. 2. Fill radiator with proper coolant mixture (as specified by the engine manufacturer) until coolant is visible in the sight gauge. 2. Pull out on switch (2, Figure 40-1) to turn the system on. 3. Push start switch (3). The "VALVE OPEN" light (5) should illuminate and the filling process will begin. 3. Install radiator cap. 4. Run engine for 5 minutes, check coolant level. 5.

If coolant is not visible in the sight gauge, repeat steps 1 through 4. Any excess coolant will be discharged through the vent hose after the engine reaches normal operating temperature. 4. When tank is full, the "VALVE OPEN" light will turn off and the “FULL” light (4) will illuminate. 5. Close the oil supply valve in the fill hose. 6. Press and hold start switch (3) for a couple of Engine coolant must always be visible in the sight gauge before truck operation. 7. Disconnect the new oil supply hose. 8. Push switch (2) in to turn system power OFF. FIGURE 40-1. 1. Remote Control Box 2. System Switch 3. Start Switch 4. “FULL” Light 5.

“VALVE OPEN” Light COOLING SYSTEM ANTI-FREEZE RECOMMENDATIONS (Ethylene Glycol Permanent Type Anti-Freeze) Percentage of Anti-Freeze Protection To: 10 + 23° F - 5° C 20 + 16° F - 9° C 25 + 11° F - 11° C 30 + 4° F - 16° C 35 - 3° F - 19° C 40 - 12° F - 24° C 45 - 23° F - 30° C 50 - 34° F - 36° C 55 - 48° F - 44° C 60 - 62° F - 52° C Use only anti-freeze that is compatible with engine as specified by engine manufacturer.