Komatsu — WHEEL MOTOR SERVICE

OM4036 Lubrication & Service - Section 40 Page 40-1 LUBRICATION AND SERVICE Recommended preventive maintenance will contrib- ute to the long life and dependability of the truck and its components. The use of proper lubricants and the performance of checks and adjustments at the rec- ommended intervals is most important. HYDRAULIC TANK SERVICE There are two sight gauges on the side of the hydraulic tank. With engine stopped, keyswitch OFF, hydraulic system bled down and body down, oil should be visible in the top sight gauge. If hydraulic oil is not visible in the top sight gauge, follow Adding Oil instructions below.

Lubrication requirements are referenced to the lube key found in the Lubrication Chart (page 40-3). For detailed service requirements for specific compo- nents, refer to the service manual section for that component (i.e. Section H for suspensions, Section L for hydraulic system, etc.). Adding Oil Keep the system open to the atmosphere only as long as absolutely necessary to lessen chances of system contamination. Refer to manufacturer's service manual when servic- ing any components of the General Electric system. Refer to engine manufacturer's service manual when servicing the engine or any of its components. Service the tank with clean Type C-4 hydraulic oil only.

All oil being put into the hydraulic tank should be filtered through 3 micron filters. The service intervals presented here are in hours of operation. These intervals are recommended in lieu of an oil analysis program which may deter- mine different intervals. However, if the truck is being operated under extreme conditions, some or all, of the intervals may need to be shortened and the service performed more frequently. 1. With engine stopped, keyswitch OFF, hydraulic system bled down and body down, check to see that hydraulic oil is visible in the top sight gauge. 2.

If hydraulic oil is not visible in the top sight gauge, remove the tank fill cap and add clean, filtered C-4 hydraulic oil (Lubrication Chart, Lube Key “B”) until oil is visible in the top sight gauge. The 930E truck is equipped with a Lincoln Automatic Lubrication System. The initial setup for this system provides for nominal amounts of lubricant to be deliv- ered to each serviced point. The lubrication injectors can be adjusted to vary the amount of lubricant deliv- ered. In addition, the timer for lubrication intervals is normally adjustable. For adjustments to these devices, refer to Automatic Lubrication System later in this manual. 3. Replace fill cap. 4. Start engine.

Raise and lower the dump body three times. 5. Repeat Steps 1 through 4 until oil is maintained in the top sight gauge with engine stopped, body down, and hydraulic system bled down. 930E SERVICE CAPACITIES WHEEL MOTOR SERVICE Due to differences in gear ratio and component evo- lution/design, wheel motor service intervals may be unit number and/or mine specific. Because of the wide variety of factors involved, it is necessary to consult your area Komatsu representative for all wheel motor service intervals and instructions. Gen- eral intervals for oil service and sampling are listed in the interval charts. Crankcase: (including 4 oil filters) Komatsu SSDA16V160 Engine Liters U.S.

Gallons 280 74 Cooling System: Komatsu SSDA16V160 Engine 594 157 Hydraulic System: Refer to “Hydraulic Tank Service” 1325 350 Wheel Motor Gear Box (each side) 76 20 Fuel Tank (Diesel Fuel Only) 4542 1200