Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE then (Machine of poor fuel arrangement specification) Additional water separator (8) is installed. Before replacing the fuel pre-filter cartridge, drain water and sediment in the additional water separator (8). not to let water get on the (5), dry it completely before 4 - 58 9. When installing, apply oil to th e packing surface and bring the packing surface into co ntact with the seal su of filter cartridge (4) and then If the transparent cap is tight is not tightened enough, fuel securely to the fixed tightenin tighten it further by 1/4 to 1/2 turns.

ened too much, the O-ring will be damaged and this will cause leakage of fu will leak through the gap at the O-ring . To prevent thes e problems, always ti g angle. new filter cartridge with clean fuel, coat the packing surface thinly with oil 10. Clean the filter holder, fill the install to the filter holder. NOTICE When adding fuel, do not remove small holes (A) on the dirty side. After adding fuel, remove cap (B) Always fill with clean fuel. Be care the fuel. In particular, center portio cap (B) when adding fuel. Be caref portion on the clean side. 11. When installing, tighten until t he packing surface contacts the seal surface of the filte r holder, then tighten of a turn.

If the filter cartridge is tighten filter cartridge is too loose, fu When tightening with a filt ed too far, the packing will be damaged and this will le ad to leakage of fuel. el will also leak from the packing, so always tighten th er wrench, be extremely careful not t o dent or damage 12. Check that the drain valve (2 13. Remove the vinyl bag coveri REMARK If water gets on the connector and the water separator moni connector (5), be extremely c connector. If water gets on connector connecting it. 14. Turn the valve (1) at the bott 15. After completing the replace ment of filter cartridge (4), bleed the a