. MAINTENANCE MAINTENANCE PROCEDURE Bleed the air as follows: REMARK Sometimes some air is still left inside water separator (3) after air bleeding, but the engine can be started by CHECK SWING PINION GREASE LEVEL, ADD GREASE Prepare a scale. 1. Remove bolts (1) (2 bolts) on the top of the revolving frame and remove cover (2). 2. Insert scale (3) into the grease through inspection and adjustment hole (A). Check that the height of grease (S) in the area passing the pinion is at least 9 mm (0.355 in). Add grease if the level is low. 3. Check if the grease is milky white. If it is milky white, it is necessary to change the grease. Please contact your Komatsu distributor.
Total amount of grease PC200: 14.6 liters (3.86 US gal) PC220: 15.8 liters (4.17 US gal) 4. Install cover (2) with bolts (1). 4 - 59 16. Fill the fuel tank with fuel (to 17. Loosen the knob of feed pu mp (7), pull it out, then pump it in and out until the movem REMARK It is not necessary to remove the plug at the top of the fuel pre-filter and fuel main filter After the engine runs out of f uel, use the same procedure to operate feed pump (7) an 18. After finishing to bleed air, p ush in the knob of feed pump (7) and tighten it. . 19.
After replacing the filter cart ridge, start the engine and run it at low idle for 10 minutes Check for leakage of oil from tightening of the filter cartrid If there is still oil leakage, re foreign material in the packin it. the filter seal surface and transparent cap mounting. If an y oil is leaking, check the ge. peat Steps 1 to 7 to remove the filter cartridge, and if any damage or embedded g surface is found, replace it with a new cartridge and repe at Steps 8 to 19 to install operating feed pump (7) until its motion gets hard. The remaining air is naturally bled whe n the water separator is left as it is for some time after th