Komatsu — 20.2.2 WATER

20.2 COOLING SYSTEM 20.2.1 GENERAL The cooling system operates under pressure which is controlled by the pressure relief valve in the radiator cap. The belt driven water pump circulates the coolant through the engine block, cylinder heads, radiator, and engine oil cooler. Circulation is controlled by the thermostat which by-passes coolant flow around the radiator until the engine reaches operating temperature. Proper cooling is possible only when the system is sealed, the radiator cap gasket is in good condition, the pressure relief valve and thermostats are operating properly. The system is free of coolant and air flow restrictions and the system is filled to the proper level.

Selection and maintenance of the engine coolant is important to long engine life. The following information provides recommendations for selecting the engine coolant, maintaining the coolant inhibitors and servicing the cooling system. The system operates successfully with a water/antifreeze mixture or inhibited/conditioned water as the coolant. Water alone allows rust, scale deposits, and corrosion to occur within this system. After 2000 hours or one year of operation, whichever comes first, the cooling system should be drained, flushed and refilled. 20.2.2 WATER Use water which has a low mineral content. water must meet the following standards:

Water used in conjunction with antifreeze, coolant filters and inhibited Total Hardness Not to exceed 170 parts per million (10 grains/gallon maximum) to prevent scale deposits. Water containing dissolved magnesium and calcium (the usual reason for water hardness) above the specified amount will cause scale deposits to develop in the engine. Chlorides Not to exceed 40 parts per million (2.5 grains/gallon maximum) to prevent corrosion. Sulfites Not to exceed 100 parts per million (5.8 grains/gallon maximum) to prevent corrosion. Dissolved Solids Not to exceed 340 parts per million (20 grains/gallon maximum) to minimize sludge deposits, scale deposits, corrosion or a combination of these.

If any of the requirements cannot be met, use distilled, de-ionized, or de-mineralized water. To determine if local water supplies meet these standards, water samples can be tested by water treatment laboratories. Softened water that is prepared using common salt (sodium chloride) contains excessive amounts of chlorides and should not be used. REMARK Never use water alone in the cooling system because corrosion will occur. 3-l 1