MAINTENANCE 21.2.1 GRADE 5 AND 8 NON-PHOSPHATE COATED HARDWARE Recommended torque for all Standard Application Nuts and Bolts, provided; all thread surfaces are clean and lubricated with SAE-30 engine oil or joints are rigid, that is, no gaskets or compressible materials are used. When reusing nuts or bolts, use minimum torque values.
THREAD GRADE 5 Nom I Ibf ft 1/4NC 8 6 I 1/4NF 1 9 I 7 I 5/16NC I 18 I 13 5/l 6NF 20 15 3/8NC 33 24 I 3/8NF 1 37 I 27 I 7/16NC 1 52 I 38 I 7/16NF j 57 I 42 1/2NC 79 58 1/2NF 88 65 9/l 6NC 114 84 I I 9/l 6NF I 126 I 93 I 5/8NC 1 156 I 115 I 5/8NF I 175 I 130 I 3/4NC I 278 I 205 3/4NF 312 240 7/8NC 414 305 I 7/8NF 1 454 I 334 I 1NC I 617 I 455 1NF 691 510 1?1/8NC 827 610 l-1/8NF 929 685 I l-1/4NC 1 1166 I 860 I l-1/4NF 1 1295 I 955 I l-3/8NC 1 1532 I 1130 I l-3/8NF 1 1749 I 1290 Multiply the standard torque by 0.65 when finished jam nuts are used, 0.7 when Molykote, white lead or similar mixture are used as lubricants, 0.75 when parkerized bolts or nuts are used, 0.85 when cadmium plated bolts or nuts and zinc bolts w/waxed zinc nuts are used or 0.9 when hardened surfaces are used under the nut or bolt head.
The General Torque must be used in all cases where SPECIAL TORQUES are not given. Values listed in this manual are lubricated (wet) threads; values should be increased l/3 for non-lubricated (dry) threads. 3-17