21.2.2 GRADE 8 PHOSPHATE COATED HARDWARE This chart provides tightening torque for general purpose applications using original equipment standard hardware as listed in the Parts Books for the machine involved. DO NOT SUBSTITUTE. Original equipment standard hardware is defined as Grade 8, coarse thread bolts and nuts and thru hardened flat washers (Rockwell “C” 38-45), all phosphate coated and assembled without supplemental lubrication (as received) condition. The torques shown also apply to the following; Phosphate coated bolts used in tapped holes in steel or gray iron.
Phosphate coated bolts used with phos- phate coated prevailing torque nuts (nuts with distorted threads or plastic inserts). Phosphate coated bolts used with copper plated weld nuts. Markings on bolt heads or nuts indicate material grade ONLY and are NOT to be used to determine required torque. 21.2.3 STANDARD METRIC FASTENERS This chart provides tightening torque for general purpose applications using original standard hardware as listed in the Parts Book for the machine involved. DO NOT SUBSTITUTE.
Original standard hardware is defined as metric class 10.9 bolts and class 10.0 nuts and thru flat washers (Rockwell “C” 38-45), all phosphate coated and assem- bled without supplemental lubrication. The torques shown also apply to the following; Phosphate bolts used in tapped holes in steel or gray iron, with phosphate coated prevailing torque nuts or with copper plated weld nuts. Markings on bolt heads or nuts indicate material class ONLY and are NOT to be used to determine required torque. 3-18