21.3 HYDRAULIC TUBES AND FITTINGS The torque figures are recommended for plain, cadmium or zinc plated fittings, dry or wet installations. Swivel nuts either swaged or brazed. Figures are for tube nuts used with 37” flared fittings and JIC - 37” seat O-Ring boss plugs and swivel nuts. 0 - RING BOSS PLUGS 21.4 HOSE CLAMPS 21.5 SPLIT FLANGE CONNECTIONS The following chart provides the tightening torques for The following chart provides the tightening torques for hose clamps used in all rubber applications (radiator, air split flange connections used in hydraulic systems. cleaner, operating lever boots, hydraulic system, fuel Flanges and fitting shoulders should fit squarely.
Install systems etc.). all bolts, finger tight, then torque evenly. Over torquing bolts will damage the flanges and/or bolts, which may TORQUE t 0.6 Nom (5 Ibf in) cause leakage. I / I I I I CLAMP TYPE AND SIZE FLANGE SIZE BOLT SIZE BOLT TORQUE Nom Ibf ft 314 ‘/2 5/I 6 318 30 to 37 22 to 27 20 to 24 15to18 1 318 37 to 47 27 to 35 l-114 7116 47 to 61 35 to 45 Worm Drive - Over 1 -3/4 in Open Diam- / 4.5t05.6 I40to50 1 ------ 1 ------ l-112 2 ‘/2 62 to 79 46 to 58 75 to 88 55 to 65 2-112 1% 107to123 79 to 91 eter 3 518 187to203 138to150 ;,“;;rt_;t;- 10.7 to 11.8 95 to 105 4.5 to 5.6 40 to 50 3-112 518 159to 180 117to133 3-l 9