Komatsu — 24.2.3 TRACK TENSION AND ADJUSTMENT

MAINTENANCE 24.2.3 TRACK TENSION AND ADJUSTMENT Proper Adjustment Tracks adjusted too tightly increase operating loads on final drives and accelerate wear on undercarriage components, especially in packing conditions. A machine in forward operation with correctly adjusted tracks will experience track loads only along the ground from the front idler to where the bushings engage the sprocket. Lubricated track systems are to be adjusted to provide a sag in the track chain between to front top idler and the front idler. Correct tension reduces stress levels throughout the undercarriage system. Checking the Tension 1.

Place a wooden block, = 305 mm (12 in) in height, under the front most track shoe lug. Drive the machine forward until the track chain is tight along the ground and around the sprocket. Apply and lock the brake pedal, lock the transmission shift lever in the NEUTRAL position and stop the engine. 2. Stand on the track between the front idler and the first track idler in order to accumulate all the chain slack at this point. 3. Place a straightedge on the track so the ends rest over the front idler and track idler. Measure the clearance between the bottom of the straightedge and the top of the shoe grouser with a ruler at the midway point between the idlers.

REMARK If the distance is more than 64 mm (2-X in) or less than 50 mm (2 in), adjust the track tension. Adjusting Tension The track chains are adjusted by hydraulic pressure. When lubricant is introduced into the front idler fork through the lubrication fitting, it acts upon the piston within the front idler fork forcing the front idler fork and front idler forward for track adjustment. a WARNING To avoid possible injury, always stand to the side of the bleeder plug when making track adjustment. The pressure in the front idler fork is held by the bleeder plug and check valve.

A loose or improper thread fit of either of these parts can allow them to be ejected by the pressure of the lubri- cant, causing possible injury. When increasing track tension, be sure the bleeder plug and check valve are properly torqued. When relieving track tension, never loosen the bleeder plug and check valve more than 2 % turns. Before adding lubricant for track adjustment, be sure the ball check and relief valve are properly torqued. 3-29