24.3 EVERY 10 HOURS SERVICE (CHECK BEFORE STARTING) 24.3.1 CHECK RADIATOR COOLANT LEVEL REMARK Check the coolant level before starting the engine. 1. Check the coolant level in radiator sight glass to make sure coolant is present. A WARNING + Hot, scalding coolant can spray out if the radiator cap is removed suddenly. Relieve system pressure by slowly turning the cap to the first notch or lifting the safety lever (if equipped). Remove the cap only after the pressure is relieved. + Use extreme caution when adding coolant to a hot radiator to avoid being burned. Wear gloves and goggles and keep face away from the filler neck. 2.
If coolant must be added, remove radiator cap by turning it to the left or counterclockwise up to the safety stop until all pressure is released. Press down on the cap and continue to turn until the cap is free to be removed. 3. Add fluid until visible in sight glass. + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8. 24.3.2 CHECK ENGINE CRANKCASE OIL LEVEL A WARNING Park the machine on level ground, stop the engine, lower all mounted equipment to the ground, move the safety lever into the vertical (down) position, apply the brake pedal lock, turn off the electrical system master switch.
Stop the engine and check level. For an accurate reading wait for the oil to drain into the crankcase pan. Open hood access door. Remove the oil level gauge (1) and wipe it clean. Reinsert the gauge completely. Remove the gauge and check the oil level. If the level is at or below the ADD mark, add oil through the filler opening (2) to bring the level up to the FULL mark on the gauge. REMARK Never run the engine if the level of the oil is at or below the ADD mark on the oil level gauge. + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8. 3-31