MAINTENANCE 24.3.3 CHECK EQUIPMENT SYSTEM HYDRAULIC OIL LEVEL 1. With the oil at operating or ambient temperature, park the machine on level ground, lower the blade to the ground, release the control lever and stop the engine. 2. Check oil level at sight gauge on the side of the reservoir. Add oil if level is below the center line of the gauge. 3. Slowly loosen the reservoir fill cap to relieve any reservoir pressure, then remove cap. 4. Add fluid to the reservoir to bring the level up to the center line of the sight gauge. Replace reservoir filler cap. + For details of the fluid to use, see 20 USE OF FUEL, COOL- ANT AND LUBRICANT ACCORDING TO AMBIENT TEMPER- ATURE on page 3-8.
24.3.4 FILL FUEL TANK A WARNING When adding fuel, never allow the fuel to over flow. This may cause a fire. If fuel is spilt, thoroughly clean up any 1. Check the fuel level using the fuel gauge. 2. After completing work, fill the fuel tank through the filler port . REMARK For details of the fuel to use, see 20 USE OF FUEL, COOLANT AND LUBRICANT ACCORDING TO AMBIENT TEMPERA- TURE on page 3-8. 3. After adding fuel, tighten the cap securely. REMARK Fuel capacity: 146 Q (38.5 gal) 3-32